New Page 1

Lower End Page

hondacb750lightenedandbalancedcrankshaft

                         Cycle X   Lightened and Balanced Crankshaft Assemblies
                         Many people have experienced the benefits of lightened and balanced crankshafts.

Cycle X crankshaft assemblies include:
* Lightened crankshaft   (not to much, not to little)
* Balanced to perfection   (state of the art balancing equipment)
* Micro polished journals (same technique as Penske racing)
* Cycle X super rods are installed with OEM Honda rod bearings.
Ready to go!

Note:
These procedures are done to your crank, but if your crankshaft is worn we have these crank assemblies in stock.

Cycle X Crankshaft Assemblies $ 989.00 # EN-0909 CALL TO ORDER

Cycle X Lightened and balanced crankshaft
Send us your Honda cb750 crankshaft and we will lighten and balance it with state of the art equipment.
$ 199.00 CALL FOR INFO

Cycle X Super Crank

This Super crank is for you serious race folks.
Cycle X super cranks weigh 15.8 lbs ( stock is 22.8 .......although stock cranks vary in weight a bit )

#SupCrank...................$399.00

Call to order!!!!!!!!

                                                              hondacb750racetransmission

                                                           Cycle X Race Transmissions.
Includes:
* Glass bead gear assemblies for inspection. ( also, makes them purdy)
* Magnaflux gears (generally an additional cost elsewhere, not here)
* Undercut gears   (a must for Hot-rod Honda sohc's)

Note:
Send us your transmission. We will inspect it and send you back one of these race prepared transmissions.
If your transmission is bad, don't worry.
We have race transmissions in stock, ready to go.

                                                                       $ 289.00            # EN-0808
                                                                           CALL TO ORDER

Lock Up Clutch Assembly

Lock up clutch.

Two things:
Some high horsepower Hondas have a tendency to have clutch slippage in high gear.
Most people will install heavy duty springs to overcome this problem, but creating a stiff feel at the lever.
Heavy springs can make your clutch lose its nice, easy operation when leaving the stop and go light.

Our lock up clutch will increase pressure with RPM
Initial off the line or stop and go light grab can be softened up with light springs to prevent wheel spin or annoying hard lever pull. .

Lock up clutch kit includes :
Billet spacer plate.
Lock-up pressure plate.
(2) Gaskets.
(2) Dowell pins.
Extended clutch adjustor.
Oh yeah, looks cool.
Note:
Kick starter shaft will need to be extended if you want to use kick only ( give a call )
Kit comes with kick shaft plug for you electric start or drag race people.

NOW IN STOCK!
$ 449.00

       Cycle X Clutch Plates
* Clutch plates meet or exceed OEM standards.
* CB750 SOHC .These sets are packaged to cover all years 69-78.
        SALE price $ 41.00 per set.
                         # EN-9999

"NEW" Cycle X charging system
* Single phase system allows battery or battery less operation. ( call for details )
* Rotor weighs only 1.640 lb's for high rev potential
* 14 amp system
* Kick only ( who needs a button anyway )
* Complete system weighs over 8 lbs less than a OEM system.

Note:
Honda's 3 phase field excited charging will create a magnetic pull when the regulator tells it.
This magnetic pull can reduce horsepower ( sometimes 2 horsepower )
Reduced rotating weight and less magnetic pull makes the Cycle X charging system the best choice.

Kit includes:
                   * 1.640 lb rotor
                   * 14 amp stator ( single phase ) and adaptor plate
                   * Crankshaft oil block-off sleeve ( Kick only )
                   * Crankshaft spacer.
                   * Starter hole block-off plug with fitting ( wires come out of this location)
                   * Solid state regulator-rectifier ( Made in USA )
                   * Gasket
                   * Instructions

                                                                            $ 449.99                #CRG-1234

Alternator block off plate with exposed charging system




Sample of the Cycle X exposed charging system.

We like this system for a few reasons.
The Cycle X charging system is great.
The throttle response is instant with the 1.640 lb rotor.
16 amp versus OEM 13 amp output.
The system is thinner than the OEM system ( for you road racer people)
And my favorite:
The exposed alternator looks cool.

* Single phase system allows battery or battery less operation. ( call for details )
* Rotor weighs only 1.640 lb's for high rev potential
* 16 amp system
* Kick only ( who needs a button anyway )
* Complete system weighs over 8 lbs less than a OEM system.

Note:
Honda's 3 phase field excited charging will create a magnetic pull when the regulator tells it.
This magnetic pull can reduce horsepower ( sometimes 2 horsepower )
Reduced rotating weight and less magnetic pull makes the Cycle X charging system the best choice.

Complete kit includes:

Block off plate and oil seal.
16 amp rotor and stator.
Voltage regulator.
Oil block off sleeve.
Starter hole plug.
Allen bolts.
Gasket.

$ 449.99

Oil cooler combo - combo
This oil cooler combo - combo kit features the Cycle X adaptor described in the above section.
We have made a complete oil cooler kit for your consideration.

Complete kit includes:
Alloy oil cooler adaptor. ( with "O" ring )
Oil filer
Chrome fittings
1/2 inside diameter hose. ( to get the oil flowing )
Hose clamps.
Frame clamp.
Chrome oil cooler.

$ 189.00

HONDA SOHC-------OIL LINE & CHROME CLAMPS------THE HIGHEST LEVEL:
Now that you have a modern high performance or stock custom Honda sohc motorcycle, you will need some oil lines to complete your high level project. Honda sohc's have larger oil lines. After you grind or cut the ugly OEM clamps off, you can install this oil line and chrome clamps. Give your motor the oil volume it needs. 1/2 ".

Oil line: $ 2.50 PER FOOT # EN-605

Chrome Clamps: $ 15.95 each # EN-606

       HEAVY DUTY CLUTCH
                     SPRINGS:
         $ 14.00         # EN-614B

Honda cb750Clutch
        nut socket:
You will need this socket to
       do your clutch change.
    $ 14.99         # EN-615

                      Cycle X==   CLICK FOR WEB PAGE   == Super-Rods
                          Cycle X Super-Rods have been designed and tested to meet the most demanding applications.
                                 Our Super Rods are are built with the latest technology and materials.
                      Our connecting rod quality will be hard to match, our price will be impossible to beat.
                                                             IN STOCK --- IN STOCK --- IN STOCK
                                                                                 $ 599.00 per set
                                                                               Not made in China

         3/8 INCH BREATHER
             $ 14.95   # md-706

1/2 INCH BREATHER
$ 14.95 # md-707

      CHROME CRANKCASE
                  BREATHER:
Bolts anywhere you would like, And it looks good too. 3/8 line.
          $ 16.00               # MD-708